GENERAL INFORMATION URC01 Urethane Kosmic Rokket Klear is the fastest drying Klear House of Kolor has ever produced. Using state of the art polymer technology, we have developed a klear with excellent chemical, fuel, water resistance, and UV protection. URC01 is ideal for Bike Tin, small parts, jambing, intercoat over artwork, and all those quick jobs that you are still looking for, that show-ready finish that House of Kolor users crave. Urethane Kosmic Rokket Klear does not require a flash time between coats: wet on wet application.NOTES: DO NOT attempt to clear complete vehicle. URC01 has been developed for use on small surfaces only. This product has an extremely fast dry time. Previous coats should be FULLY FLASHED or at RECOMMENDED CURE TIME before applying the URC01. NOT RECOMMENDED for application over the MC Kosmic Krome line, Urethane Kandys, or use as a Kandy Karrier. SUBSTRATE All House of Kolor standard basecoats, Solid Graphics and artwork. Properly cured and prepared OEM finishes COMPONENTS URC01 - Urethane Kosmic Rokket Klear KU152 - Kosmic Exempt Catalyst RU310 - Fast Reducer 65F to 75F RU311 - Medium Reducer 75F to 85F RU312 - Slow Reducer 85F to 95F RU313 - Very Slow Reducer 95F to 100+F MIXING RATIO For 2.1 lb/gal (250 g/L) VOC Compliance (Low VOC) - (4:1:0-5% by volume) 4 parts URC01 Urethane Kosmic Rokket Klear 1 part KU152 Catalyst Optional: 0-5% RU310 - 313 Series Reducers PREPARATION Please be aware that Shimrin2® bases, Kandy Basecoats and Klears can be susceptible to staining or bleeding from plastic fillers, putties, fiberglass resins and some primers. To prevent staining, Please refer to the tech pages on KD3000 Series DTS Foundation Surfacer Sealers, or KP series. Under layers should be FULLY FLASHED or at RECOMMENDED CURE TIME before applying the URC01. DRY TIME 10 minutes Dust Free 30 minutes Nib Sand & Buff 60 minutes - Wet Sand, buff & Deliver NOTE: Dry times may vary due to air temperature, humidity, airflow, and film thickness. If cutting and buffing is desired, the product must be wet sanded and buffed within 3 - 4 hours after application. FLASH TIME No flash time between coats for most surfaces. Apply two full wet-on-wet coats. Small or curved parts/objects with multiple inverted angles, RECOMMEND 1-2 minutes flash between coats. DO NOT EXCEED more than 5 minutes. Longer flash times between coats may cause dulling or flat appearance. CLEAN UP Clean equipment thoroughly with lacquer thinner or urethane reducer (check local regulations)
Checkout happens on the official store. This page mirrors catalog facts in plain HTML for direct reading and crawlability.
