(NOT SUITABLE FOR LDPE OR PRE MOULDED PONDS)Before painting check your surfaces for imperfections, cracks etc and fill where appropriate. For large cracks in the concrete, vee out the cracks to approx 10mm - make sure the surface to be bonded is solid and dust free. Fill with Gold Label Pond & Aquarium Sealer. Painting can then commence immediately. Although Aqua Pond Paint is much safer than normal resin systems, it is recommended you should avoid contact by using barrier cream or gloves. Any splashes should be washed off with soap and water. - No primer needed - 2 coats only (on smooth surface) - Can be applied to ‘damp’ surfaces - Water based, so less hazardous - Quicker pond refill - Easy tool clean-up - Packed in easy-to-mix bucket - Easy to apply with brush, roller or spray - 40sq.mtr / 5ltr coverage (on smooth surface) Method of Use IMPORTANT: DO NOT apply in temperatures below 10°C (including overnight temperatures) Add the hardener in the top unit to the paint in the bottom unit and stir thoroughly, making sure it is completely mixed - VERY IMPORTANT -stir for a minimum of 2 minutes. PLEASE NOTE - Once mixed, the paint is usable for 1.5 hours in ambient temperatures. Over 20°c the working time will be reduced. After mixing, apply immediately by brush, roller or spray. Ensure the coating is worked into the corners etc. Apply minimum of 2 coats. The second coat can be applied when the first is touch dry after approx 6-8 hours at 20°c. The same for any subsequent coats. The paint will cure hard in 12 hours and full cure in 3-7 days, depending on atmospheric conditions. When fully cured, wash the painted surface and drain before final fill. Can be Used on Concrete, Blocks, Brick, Tiles, Fibreglass & Plastic For an ideal Pond Liner Patches & Pipe Repair Tape
Checkout happens on the official store. This page mirrors catalog facts in plain HTML for direct reading and crawlability.
